GUANGZHOU BIAOPAI SANITARY WARE CO.,LTD.

1.Failed to adjust the power of jet

Reason:	The small electromotor in the air control box cannot move and that leads to the failure of the valve's flexing. Or maybe the pipe leaks air.
Check:	1.If pipe leakage, or tie-in loose 2.If connection pole loose 3.If the plastic valve locked 4.If air switch button is broken 5.If the connection between the air switch & the pipe loose 6.If the air switch out of order 7.If the line connection is loose 8.If the air pipe is blocked 9.If the electromotor is burnout

2.water pipe leakage

Check:

1.If the connection tight
2.If the cool & hot water faucet is loose
3.If the valve out of order

3.Steam box water leakage

Reason:

usually leakage is aroused from wrong installation. If the installation was done carefully, that will be avoided. Please use glass cement when found the leakage.

1.leakage when power off:
A: Pipe broken
B: Pipe connection is too loose or to tight
C: Resident water & pipe system problems
2.leakage when using steam.
A:
B: Water tank is damaged
C: The joint 0f steam generator and water tank is broken
D: The venthole of the steam generator is not sealed well.
3.leakage when using the jets
A: The steam box is not sealed with or the glass cement loose.
B: The glass door is not sealed well.
C: The air control switch of the steam box with bathtub is not sealed well.
D: The electric valve for the jets is out of order
4.leakage when water runs out
A: Check the drainage
B: Drainage pipe is broken
C: Drainage moves away from the sewer.
D: The sewer is blocked.

4.Nozzle fails to jet or jet softly

A.Fail to jet: check the electric valve if in power
1. If no power, then the circuit is out of order; if the electric board fails to display, then it is out of order; if the electric board works well then just check the audion , if it is burnout.
2. If in power, check the electric valve if in order.
3. If the electric valve works well , then check if water can runs smooth or blocked.
4. Check if the water shift turns to the jet position or not
B.Jet softly.
1. The resident water pressure is too low
2. Adjust the jet gasket to make the water jet from the three holes.
3. The joint or the jet hole blocked.
4. The water valve is not opened completely

5.The exhaust fan cannot turn.

A.Failure after installation
1. Check if you upend the anode & cathode
2. If the link connected wrongly
B.Failure after use
1. If the electric bnc connector plugs loose
2. If contact well
3. If the line jointing loose
4. If no electricity, then the electric board or the circuit is out of order.

6.Radio without sound or can not reach any channel

1. If there is no any radio & circuit sound, For F1 series failure always aroused on the electric board. While For F2 series failure from the circuit.
2. F2. if hearing the channel signal sound after turning on the radio, then check if the speaker works well or not.
3. If there is no channel signal sound, Then the small relay which controls the radio must be out of order.

7.The fuse burns out or the house electric valve trips when using steam.

If that happens after using a period of time, it shows that the capability of the creepage switch & the fuse is too limited.It will be normal to change a better one.